Load Bearing: More Than 30 Tons
Warranty: 18 Months
Body material: GB Cast Aluminium alloy
Power supply: USA Brand Flexible High Efficient Solar Panel (2.5V/0.38W)
Visual distance: > 800m
Working Mode: Flashing or Constant
Waterproof: IP68
Shank: With shank or Without shank
Body material: PC(Japan Brand)
Warranty: 12 Months
Power supply: USA Brand Flexible High Efficient Solar Panel 5V/0.4W
Visual distance: > 800m
Load Bearing: 20 Tons
Working Mode: Flashing or Constant
Waterproof: IP68
Shank: Without shank
Load Bearing: More Than 40 Tons (can be installed in the middle of the road)
Warranty: 18 Months
Body material: Aluminium(GB-ADC-12)+PC(Japan Brand)
Power supply: USA Brand Flexible High Efficient Solar Panel
Visual distance: > 800m
Working Mode: Flashing or Constant
Waterproof: IP68
Two-way cycle tracks (also known as protected bike lanes, separated bikeways, and on-street bike paths) are physically separated cycle tracks that allow bicycle movement in both directions on one side of the road. Two-way cycle tracks share some of the same design characteristics as one-way tracks, but may require additional considerations at
Guidelines for Road Markings UTTIPEC 2 CONTENTS 1. Introduction 4 2. Functions of Road Markings 4 3. Types of Road Markings 5 4. Carriageway marking 5 5. Object Marking 21 6. Markings at Hazardous location 21 7. Markings for Parking 23 8. Material and
The design of the pedestrian network 15-55 Table 15.2 covers the key design issues for the elements within kerb ramps [6, 13, 42, 92, 134, 139]. figure 15.3 shows a typical kerb ramp design for a footpath with a kerb height of 100 mm that incorporates these
6/8/2021 · 620.2.5 Other White Longitudinal Pavement Markings (MUTCD Section 3B.05) Standard. A channelizing line shall be a wide or double solid white line. Option. Channelizing lines may be used to form channelizing islands where traffic traveling in the same direction is permitted on both sides of the island. Standard.
Approaches on Tamu – Kyigone – Kalewa Road Section from km 0.00 to km 149.70 in Myanmar MEA 5-1 5. DESIGN STANDARDS AND SPECIFICATIONS Design standards for this project will of State Highways : SP:73(IRC-2007)”, “Specification for Road and
Road markers ideal for improving visibility to driveways and road edges. Measuring 3" x 8". $7.00 - $7.50. More Details. RF-9. Diamond Reflector 18" x 18". Reflectors for drawing attention to road hazards. Measuring 18" x 18" with 9 - 3" plastic buttons on aluminum
Find documents by disciplines The Design Manual for Roads and Bridges (DMRB) contains information about current standards relating to the design, assessment and operation of motorway and all-purpose trunk roads in the United Kingdom.